Follow

VIGGO BOX PHYSICAL INSTALLATION

Follow the steps below to complete the physical installation of the Viggo box:

 

A. Place the Viggo box in its bracket at the appropriate location (usually behind the TV).

B. Connect the antenna to the back of the box or to the TV depending on the required setup.

C. Connect electricity to a continuous (always on) power source.

D. Connect HDMI cable to the correct TV input (usually HDMI 1). Configure the TV to power on to this input by default: use the Source or Input button on the TV remote to select the HDMI channel to which the box is connected.

E. Pair remote control with the dongle on the back of the box, according to the remote model you have: MK1, MK2, MK3 or MK4.

F. Register box by referring to chapter II.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk