Follow

PAIRING PROCEDURE

A. Press OK and Back buttons to enter pairing mode – remote LED will start blinking rapidly.

B. Insert dongle into the Viggo box USB port, or reboot box if the dongle is already inserted. The remote LED will stop blinking within a few seconds, indicating the remote and dongle are paired.

C. Press OK/Select. A cursor will appear on-screen.

D. Remote is now paired with the dongle.

Note: Steps VII-1 and VII-2 above must be performed within 15 seconds or the pairing process will automatically stop and need to be restarted.

 

If the remote still does not function, proceed to check remote dongle:

H. Make sure the dongle is connected and properly inserted in the USB port. If there is no dongle, the remote must be replaced.

I. Check that the Viggo remote is working. Press SmartTV to activate the cursor and move around the Viggo interface

J. If the cursor does not activate, the remote needs to be re-paired to the dongle as per the procedure below.

 

Turn remote to keyboard side.

K. Press [w] and [o] keys together until the Tab button flashes orange, and release.

L. Insert dongle into the Viggo box USB port or, reboot box if the dongle is already inserted.

M. Keep remote control close to dongle until the Tab button stops flashing orange.

N. Turn remote to Remote Control side and press Viggo or SmartTV (depending on the remote model). A cursor will appear on-screen.

O. Remote is now paired with the dongle.

Note: Steps 1 and 2 above must be performed within 15 seconds or the pairing process will automatically stop and need to be restarted.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk