Follow

IR TV FUNCTIONS

A. Follow the steps below to clone IR functions from a working remote control (Master) to a new or partially trained remote control (Trainee).

IR trained buttons to include Power, SmartTV, TV, CH+, CH-, VOL+, VOL-, Mute, Back, Numeric

Keypad, Backspace, Prec, Subtle, Guide, Red, Blue, Green, Yellow and 0-9.

 

Remote control cloning procedure is as follows:

B. Place Master and Trainee remote next to each other.

C. Press and hold the TV button on the Trainee remote for 10 seconds, until the remote LED

starts blinking. The Trainee remote is now in IR training mode.

D. Press and hold the OK and TV buttons together on the Master remote for 5 seconds, until the remote LED starts blinking. The Master remote is now in transmitting mode.

E. When the cloning process is complete, Trainee and Master remote LED will stop blinking.

After cloning, test all IR-assigned keys for proper operation. If selected keys do not work as expected, try cloning the remote again, or IR train selectively by following the steps below:

F. Place the Master (training) and Trainee remotes face to face, about 5cm apart.

G. Press and hold the TV button on the Trainee remote for 10 seconds, until the remote LED

starts blinking. The Trainee remote is now in IR training mode.

H. On Master remote, press the key you would like to IR train on the Trainee remote. The

Trainee remote LED will begin blinking rapidly, indicating the IR code was received.

I. Press the corresponding button on the Trainee remote to assign capture IR code. The remote LED will resume slowly blinking, indicating it is ready for the next command.

J. Repeat steps VIII-8 and VIII-9 for all remaining buttons.

K. Press the Rewind button to exit IR learning mode.

Notes:

  1. Remote exits learning mode if no keys are pressed for 15 seconds.
  2. To clear IR commands learned, press the Red, Green, Yellow, and Blue buttons together on the Learning remote for 10 seconds until the LED flashes.

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk